Promoting effect of water vapor on particle matter combustion in a low-temperature continuous regeneration type PM removal device using a fluidized bed

K. Yokoo, Hideki Matsune, Masahiro Kishida, June Tatebayashi, Tsuyoshi Yamamoto

研究成果: ジャーナルへの寄稿学術誌査読

6 被引用数 (Scopus)

抄録

A fluidized bed type particulate matter (PM) removal device has been developed by focusing on the adhesion force under condition of non-water vapor. This device efficiently collects fine PM and can be operated as a low-temperature continuous regeneration device. The exhaust gas of a combustor includes water vapor at concentrations of 5–15 vol%. To further develop this device, the effect of water vapor on the continuous regeneration was investigated. The collection efficiency increases due to the water vapor. The reaction rate constant increases with increasing water vapor and with decreasing PM diameter. It is shown that water vapor promotes PM combustion at 250–400 °C. A smaller PM suits PM collection and combustion because smaller PM results in relatively larger adhesion force and well contacts the oxidant by dispersing it on the bed particles. The continuous regeneration temperature decreases to 380 °C due to the water vapor under optimal conditions.

本文言語英語
ページ(範囲)657-666
ページ数10
ジャーナルPowder Technology
355
DOI
出版ステータス出版済み - 10月 2019

!!!All Science Journal Classification (ASJC) codes

  • 化学工学一般

フィンガープリント

「Promoting effect of water vapor on particle matter combustion in a low-temperature continuous regeneration type PM removal device using a fluidized bed」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル