Ni-Fe bimetallic anode as an active anode for intermediate temperature SOFC using LaGaO3 based electrolyte film

Tatsumi Ishihara, Jingwang Yan, Masashi Shinagawa, Hiroshige Matsumoto

研究成果: ジャーナルへの寄稿学術誌査読

97 被引用数 (Scopus)

抄録

Effects of additives to Ni anode were studied and it was found that the anodic overpotential can be suppressed by addition of Fe. La0.9Sr0.1Ga0.8Mg0.2O3 (LSGM) film was deposited on the dense anode substrate consisting of NiO(Fe3O4)-Sm doped CeO2. After in-situ reduction of NiO and Fe3O4 in the dense substrate, the substrate turned to be porous, however, change in size was not large by mixing with SDC. As a result, LSGM dense film with few micrometer thickness was successfully obtained on the porous Ni based anode substrate. By optimizing the thickness of the LSGM film and application of SDC interlayer, the high power density of SOFC single cell using LSGM/SDC bi-layer film as electrolyte at decreased temperature was fabricated and the electrical power generating property was measured as a function of temperature. The high maximum power density could be achieved to a value of 2 W/cm2 at 873 K. Even at 673 K, the maximum power density of ca. 80 mW/cm2 is exhibited and this high power density was a result of the low electrolyte resistance and the small anodic overpotential of Ni-Fe bimetallic anode.

本文言語英語
ページ(範囲)1645-1650
ページ数6
ジャーナルElectrochimica Acta
52
4
DOI
出版ステータス出版済み - 12月 1 2006

!!!All Science Journal Classification (ASJC) codes

  • 化学工学一般
  • 電気化学

フィンガープリント

「Ni-Fe bimetallic anode as an active anode for intermediate temperature SOFC using LaGaO3 based electrolyte film」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル