The crosshead bearing in large two-stroke diesel engines operates under severe lubrication conditions, because the bearing oscillates within a small angle at a low speed and is always subject to a high downward load. The recent trend towards more compact engines with increased output raises the bearing specific load, thereby causing the lubrication severity to increase significantly. Thus it is very important to improve the load carrying capacity of the crosshead bearing. In the present study, experiments using a dynamically loaded bearing seizure test apparatus were carried out to clarify the influences of the clearance ratio and the oil-groove geometry on the load carrying capacity. The electrical resistance of the oil film was also measured to evaluate the extent of the oil film formation. The major results are : (1) A decrease in the clearance ratio is effective in enhancing squeeze action on the entirety of the bearing pads, thereby improving the load carrying capacity. When the clearance ratio becomes too low, however, the ability to form an adequate wedge film is degraded, causing the load carrying capacity to decrease, (2) Because incorporating the taper geometry on both sides of the oil-groove promotes a thicker oil film, a significant improvement in the load carrying capacity can be expected ; and (3) The maximum load carrying capacity is achieved by the taper geometry of a subtended length of 5 degrees and a taper angle of 0.1 degree.
|ジャーナル||Nihon Kikai Gakkai Ronbunshu, C Hen/Transactions of the Japan Society of Mechanical Engineers, Part C|
|出版ステータス||出版済み - 3月 2005|
!!!All Science Journal Classification (ASJC) codes