Fuel flexibility in power generation by solid oxide fuel cells

K. Eguchi, H. Kojo, T. Takeguchi, R. Kikuchi, K. Sasaki

研究成果: ジャーナルへの寄稿学術誌査読

252 被引用数 (Scopus)

抄録

Power generation characteristics of solid oxide fuel cell (SOFC) with internal steam reforming of hydrocarbons were investigated. Steam reforming reaction over a Ni-YSZ cermet catalyst attained almost the equilibrium conversion and selectivity in the fixed bed reactor at 1000 °C. The conversion of internal reforming of hydrocarbons was incomplete because of the limited contact time with a thick layer of the Ni cermet electrode. Therefore, the fuel cell supplied with pre-reforming gas to the anode always gave rise to a lower terminal voltage because of the insufficient conversion of fuel compared with that supplied with post-reforming gas at a given current density. Methane internal reforming proceeded without deterioration with time, whereas the power generation with ethane and ethylene suffered from carbon deposition even at high steam-to-carbon ratio. Carbon deposition region and equilibrium partial pressure of oxygen in the C-H-O diagram were estimated from the thermodynamic data. The effect of the gas composition in the power generation characteristics, especially, difference in reactivity between H2 and CO, was investigated. The H2-H2O and CO-CO2 fuel systems led to almost the same open circuit voltage at the same H2/H2O and CO/CO2 ratios at 1000 °C, as expected from the thermodynamic equilibrium. The output voltage in a discharge condition was always higher for H2-H2O than for CO-CO2 at every current density.

本文言語英語
ページ(範囲)411-416
ページ数6
ジャーナルSolid State Ionics
152-153
DOI
出版ステータス出版済み - 12月 2002

!!!All Science Journal Classification (ASJC) codes

  • 化学一般
  • 材料科学一般
  • 凝縮系物理学

フィンガープリント

「Fuel flexibility in power generation by solid oxide fuel cells」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル