Electrically controlled optical-mode switch for fundamental mode and first order mode

Ryan Imansyah, Tatsushi Tanaka, Luke Himbele, Haisong Jiang, Kiichi Hamamoto

研究成果: ジャーナルへの寄稿学術誌査読

10 被引用数 (Scopus)

抄録

We have proposed an optical mode switch, the principle of which is based on the partial phase shift of injected light; therefore, one important issue is to clarify the proper design criteria for the mode combiner section. We focused on the bending radius of the S-bend waveguide issue that is connected to the multi mode waveguide in the Y-junction section that acts as mode combiner. Long radius leads to undesired mode coupling before the Y-junction section, whereas a short radius causes radiation loss. Thus, we simulated this mode combiner by the beam-propagation method to obtain the proper radius. In addition, we used a trench pin structure to simplify the fabrication process into a single-step dry-etching process. As a result, we successfully fabricated an optical-mode switch with the bending radius R = 610 m. It showed the successful electrical mode switching and the achieved mode crosstalk was approximately %10 dB for 1550nm wavelength with the injection current of 60mA (5.7 V).

本文言語英語
論文番号08RB06
ジャーナルJapanese journal of applied physics
55
8
DOI
出版ステータス出版済み - 8月 2016

!!!All Science Journal Classification (ASJC) codes

  • 工学一般
  • 物理学および天文学一般

フィンガープリント

「Electrically controlled optical-mode switch for fundamental mode and first order mode」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。

引用スタイル