Development of in-situ micro-debris measurement system

Yukihito Kitazawa, Haruhisa Matsumoto, Toshiya Hanada, Toshifumi Yanagisawa, Atsushi Karaki, Akira Sakurai, Funakoshi Kunihiro, Tetsuo Yasaka, Sunao Hasegawa, Maki Nakamura

研究成果: 書籍/レポート タイプへの寄稿会議への寄与


JAXA has been developing In-Situ Debris Environment Awareness System. The objective of the system is to measure small size debris (between 100 μm and several cm). The distribution and flux of the debris of the size range are not well understood. The size range is difficult to measure from the ground observation, although the impact risk evaluation on space system caused by the size range is important. For the measurement system on the size range, combination of an optical sensor and a dust detector is under studying by JAXA with JAXA's collaborators. The in-situ measurement of the size range is useful for; 1) verifications of meteoroid and debris environment models, 2) verifications of meteoroid and debris environment evolution models, 3) real time detection of unexpected events, such as explosions and/or collisions on an orbit. In present status, in-situ optical observation system is under conceptual study and a dust sensor is already in BBM (Bread Board Model) phase. This paper reports the study results of measurement system and describes details of the development of dust sensor. The dust sensor especially to monitor the size range 100 μm to a few mm, must have a large detection area, while the constraints of a space environment deployment require that these systems be low in mass, low in power, robust and have low telemetry requirements. JAXA has been developing a simple in-situ sensor to detect dust particles ranging from a hundred micrometers to several millimeters. Multitudes of thin, conductive strips (material: copper) are formed with fine pitch (pitch: 100 μm) on a thin film of nonconductive material (thickness: 12.5 μm, material: polyimide). A dust particle impact is detected when one or more strips are severed by the perforation hole. The sensor is simple to produce and use and requires almost no calibration as it is essentially a digital system. BBM model was manufactured successfully with applying printed wiring board product technology. The sensor area of BBM is 35 cm x 35 cm, and thermal-strain experiments and hypervelocity impact experiments on the BBM model were performed.

ホスト出版物のタイトル62nd International Astronautical Congress 2011, IAC 2011
出版ステータス出版済み - 2011
イベント62nd International Astronautical Congress 2011, IAC 2011 - Cape Town, 南アフリカ
継続期間: 10月 3 201110月 7 2011


名前62nd International Astronautical Congress 2011, IAC 2011


その他62nd International Astronautical Congress 2011, IAC 2011
CityCape Town

!!!All Science Journal Classification (ASJC) codes

  • 航空宇宙工学


「Development of in-situ micro-debris measurement system」の研究トピックを掘り下げます。これらがまとまってユニークなフィンガープリントを構成します。